Vital V-HANGGER

Vital V-HANGGER

Used for various jobs, at various sites

• Pull out trees
• Install submerged pumps
• Hume pipe burial construction

How to use

VK-10 (for 1 ton)

1. Get 3 metal pipes for legs or for gas pipe) of 48.6mm diameter and approximately 3mm thick.
2. Insert the pipes in the joints and firmly tighten the bolts.

Keep the pipes upright and firmly tie the legs together with roper between them.

VK-20 (for 2 ton)

1. Get 3 wood poles/metal pipes (approximately 4 mm thick)
2. Insert the tips of the pipes so they hit the joint backs, and firmly tighten using U bolts.
3. After completing steps 1 and 2, decide the position of legs and stand up the structure.

Firmly tie the legs together with rope between them.

Precautions during use

Firmly tie the legs together with a rope so that they do not spread too wide apart. For 1 ton, the legs can be easily tied with ropes by fitting separately sold non-skid knobs (spikes) on the legs.

If the legs are not tied with rope on solid ground,

1. The legs may spread too wide apart and cause damage.
2. The legs may slip and cause the hanging load to fall.

Vital V-HANGGER,Hang a chain block,Vital ,Vital V,Used for Pull out trees,chain,Hang a chain ,Used for Install submerged pumps,Used for – Hume pipe burial construction,VK-10 ,VK-20 ,VKS-10,V-HANGGER,VK-10 1 ton,VK-20 2 ton